Emperial sizes on dies

either 3/8 or 7/16" open wrenchs Google copied from Lee site.

Which emperial size spanners fit on regular dies?

The US forums mention 7/16, 1/2, and 1⅛ or 1³/16.

I know that one can use standard metric sizes, but I have a chance to buy the right goodies.

They differ. Lee use one set of nut sizes, but Hornady may or may not use the same.

Meet om te weet.

Ek het by 'n pandjieswinkel 'n paar ou spanners gekoop:
½", ¾, ⅜, ⁷⁵¹⁶, ens.

Ek het by 'n pandjieswinkel 'n paar ou spanners gekoop:
½", ¾, ⅜, ⁷⁵¹⁶, ens.

***************************
Selfde storie hier.

For those in the Cape, go to Milnerton flea market on a Sunday morning. There are two stalls there that usually have most of whatever spanners you want.

How about using a Swedish nut rounder?

How about using a Swedish nut rounder?

Nah, this is a job for a 9 inch Kalahari Nut Lathe.

How about using a Swedish nut rounder?

The rounders work well, but this round it is simply my sense of correctness kicking in. It is far easier and more thorough to have the correct tool for the job at hand.

Adjusting and readjusting something which never fits properly - I think that is how adultery must feel ;)

How about using a Swedish nut rounder?

Nah, this is a job for a 9 inch Kalahari Nut Lathe.

That's a new one for me. ;D Adjusting spanner or a bobbejaan spanner?

That's a new one for me. ;D Adjusting spanner or a bobbejaan spanner?

***********************
duuude !!!!!!!!!!!!!!!! No one that loads high precision ammunition will admit to use a shifting spanner :o - Its like picking your nose, we all know but we all don't. ::)

Nothing beats a water pump pliers and a blou-draad tang.

How about using a Swedish nut rounder?

Nah, this is a job for a 9 inch Kalahari Nut Lathe.

That's a new one for me. ;D Adjusting spanner or a bobbejaan spanner?

Was a new one for me too ;-). I think it will need to be for the spanner. The bobbejaan would be more of a Cullinan Nut Crusher.

How about using a Swedish nut rounder?

Nah, this is a job for a 9 inch Kalahari Nut Lathe.

That's a new one for me. ;D Adjusting spanner or a bobbejaan spanner?

Was a new one for me too ;-). I think it will need to be for the spanner. The bobbejaan would be more of a Cullinan Nut Crusher.

I have known that thing as a Free State Micrometer...

Also know as the spanner that can be adjusted to make any size bolt or nut round.

Also known as a diver's vernier.

STILLSON wrench

Sort of like a WENCH - for all seasons .. especially OKtober - especially IMPERIAL ones from the old German EMPIRE